Whirlpool DU1050XTPQ0 Service Pointer page 2

WASH MOTOR REPLACEMENT PROCEDURE PROJECT# R14165
UNITS INVOLVED:
Specified Whirlpool brand PLASTIC "TALL TUB" models built with-in serial range specified below:
WHIRLPOOL
FR 22 TO FR 24
CORRECTIVE ACTION:
Open the door and confirm that the dishwasher is a PLASTIC TALL TUB model and falls with-in the specified serial range
above. If the dishwasher meets this criteria, replace the wash motor assembly with part number #8194160.
NOTE: IF the dishwasher was manufactured with a stainless steel tub, is not a plastic tall tub model, or falls outside the
specified serial range above, no further action is necessary.
READ THE BELOW INSTRUCTIONS IN THEIR ENTIRETY BEFORE PROCEEDING.
1. Unplug the dishwasher or disconnect power.
2. Open the dishwasher door and remove the lower dish
rack.
3. Remove the upper dish rack.
4. Remove the lower spray arm by holding the spray arm
stationary turning the center stud clockwise.
5. Remove the upper spray arm water feed tube by first
removing the two screws securing the tube to the
dishwasher tub.
6. Turn the feed tube clockwise to disengage it from the
pump and remove it from the dishwasher.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death
or electrical shock.
NOTE: If the dishwasher is not installed under a counter
top in a recessed area and the utilities are disconnected,
lay the dishwasher on it's back and skip STEP 7.
7. For better access, remove outer door panel by
removing the eight T-15 Torx screws securing the panel
to the inner door.
8. Remove the lower access panel and toe panels.
9. Remove the wiring connectors from the soil sensor
and drain pump.
CENTER STUD
NOTE: When removing terminals, grasp the terminal
behind the spade connector with a pair of locking pliers so
as not to damage it. The connector can loosen if it is
removed by rocking it. Always pull the connector straight
off.
10. Remove the thermistor by turning the thermistor one
quarter turn counterclockwise and pulling it out of the
sump.
11. Place a shallow pan or a towel under the soil sensor
to catch any water that may be present in the drain
hose.
SOIL SENSOR
DRAIN PUMP
THERMISTOR