Table of Contents
Advertisement
2
OpenVMS Installation
This chapter contains the following sections that describe how to install the A7011A or A7012A adapters on
an OpenVMS system:
•
"Preparing for Installation"
•
"Installing the Adapter"
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
HP welcomes your input. Please email us at: netinfo_feedback@cup.hp.com with comments or suggestions on
HP I/O Cards or related documentation.
All product documentation, including a comprehensive support guide, installation guide, release notes, as
well as information on supported servers, OpenVMS versions, drivers, and patches, is available online at:
http://docs.hp.com
1. Click on "browse by topic".
2. Click on "networking and communications".
3. Click on the 1000Base-T and 1000Base-SX (Gigabit Ethernet) product category.
NOTE
Installing the adapter requires proficiency in both hardware configuration and software
administration.
NOTE
These instructions apply to the A7011A (1000Base-SX--fiber-based) and A7012A
(1000Base-T--copper-based) PCI-X gigabit Ethernet cards on OpenVMS V8.2 and higher. The
Base-T cards operate at 10 or 100 Mbit/s in either full- or half-duplex modes and at 1000 Mbit/s
only in full-duplex mode. The 1000Base-SX cards operate only at 1000 Mbit/s and in full-duplex
mode. Ensure that you set both your switch and gigabit Ethernet card to autonegotiation or set
both to the same speed and duplex mode. The LAN card driver is included in the OpenVMS
V8.2 (or later) installation.
Preparing for Installation
Installation of an adapter requires disassembly of a few system components. Before beginning the
installation, see the OpenVMS system documentation for detailed instructions on installing host bus
adapters in the PCI slots.
NOTE
The maximum number of Gigabit NICs you can install in any OpenVMS system is equal to the
maximum number of corresponding card slots in the system. For example, if a system has four
PCI card slots, you can install four Gigabit NICs in that system, assuming that all the PCI card
slots are empty.
Chapter 2
13
Advertisement
Table of Contents
