Remote Control; Cooler Location - Honeywell ES800 User Manual

USE & OPERATION (CONTINUED)

REMOTE CONTROL

Note:
• The remote control requires a CR2032 (1 x 3V) coin type or equivalent battery for replacement.
• Open the battery compartment at the back of the remote control and insert the battery inside.
Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
• Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
• Do not mix old and new batteries.
• Do not recharge the battery.
Exhausted batteries are to be removed from the product and safely disposed of as per local
•
regulations.
Do not dispose of batteries in fire. Batteries may explode or leak.
•
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.

COOLER LOCATION

Make sure to position the air cooler correctly before you set up and start using the product.
Please refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
Power : ON / OFF
Fan Speed : Low / Medium / High / Auto
Swing : Controls the motion of the louvers
Cool : Evaporative cooling on/off
Timer : Controls the Timer function for automatic off
QuietSleep / : QuietSleep
TM
TurboBlast
TM
EN
/ TurboBlast
TM
3
mode
TM