Blower Function; Cleaner Maintenance - Hoover TWDH1400 Instruction Manual

BLOweR fUNCTION

The cleaner can be used as a blower for leaves, dust, etc.:
1. switch off cleaner.
Release the hose assembly, rotate the hose, anticlockwise until un-locked. [9]
2.
re-connect the hose assembly to the blower outlet ensuring it locks fully into
place.[10]
3. Close the suction regulator. [2]
4. switch the cleaner on by pressing the on/off switch on the cleaner main body.
5. Do not blow towards people or animals.
Parking and Storage Section [11]
1. The tube can be parked on back or on the bottom of the cleaner for storage.
or temporary storage while in use.
2. Crevice tool can be inserted into the base of cleaner.

CLeANeR MAINTeNANCe

Removing and replacing the dust bag
If the suction is low please check if bag requires to be emptied, cleaned or if necessary
replaced.
1. switch off the cleaner.
2. The hose must be detached from the cleaner prior to the dust bag being removed .
3. Release the securing latches and remove the top cover.[12]
Remove the dust bag upwards. [13]
4.
NOTe: Remove the hose assembly before taking out the dust bag.
Remove the sealing strip. [13]
5.
6. Empty the dust from the bag and dispose of it correctly and carefully. [14]
Wash it in hand warm water [16], and allow it to dry [17].
7.
Cleaning the filter:
To maintain optimum performance of your cleaner, please wash the pre-motor filter and
exhaust filter when suction decreases.
Cleaning the pre-motor filter:
1. Remove the pre-motor filter by rotating it anticlockwise
Wash it in hand warm water [16], and allow it to dry [17] thoroughly before replacing
2.
to the cleaner
ReMeMBeR: Do not use hot water or detergents. In the unlikely event of the
filters becoming damaged, fit a Genuine Hoover replacement. Do not try and
use the product without a dust bag or filter fitted.
9
GB