The range data plate specifies the model number, serial number and electrical supply requirements. It is located on the Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive left side wall inside the range storage compartment.
Use common sense and caution when installing, maintaining or operating this or any other appliance. WARNING Always contact the Dacor Customer Service Team about problems Hazards or unsafe practices that COULD result in severe and conditions that you do not understand.
Dacor is not responsible for service required to correct a • To prevent injury due to the unit tipping forward, secure the faulty installation. The owner is responsible to make sure oven to the cabinet using the supplied mounting screws.
Hood • The range may be installed flush to the rear wall. Dacor recommends installing a noncombustible material on the 13" (33.0 cm) rear wall above the range and up to the vent hood. It is not 36”...
Page 7
Installation Specifications Backsplash 1/4" (6.4 mm)* Vertical Min. flat ledge non-combustible rear wall surface 20 1/2” 4 13/16” (52.1 cm)* (12.2 cm) Max. 10" (25.4 cm) min. Front of to combustible side countertop walls above the range 3” (7.6 cm) Max. (both sides) Cabinet face, 13/32”...
• Anti-tip bracket with fasteners and anchors: screw, • Oven racks 4 places • Razor blade scraper (see text) • Dacor Cooktop Cleaning Cream Installing the Anti-Tip Bracket Anchor, 4 places: use for concrete Locate the anti-tip bracket included in the parts box. floor only There are two ways to mount the anti-tip bracket: •...
Page 9
Installation Instructions Attaching the bracket to a concrete floor: Determine if the base plate is as high at the notches by drilling test holes into the wall at both dots with a • Drill four (4) 3/8” diameter countersink holes through any 1/16”...
Installation Instructions Removing the Oven Door Electrical Connection To make the range easier to move, remove the door to reduce WARNING weight. • This range must be connected to a grounded, metallic, WARNING permanent wiring system. Alternatively, a grounding conductor should be connected to the grounding terminal or • Do not attempt to disengage the hinge catches with the lead on the appliance.
Page 11
Installation Instructions Option 1 - Connecting to a Four-Wire Connection to power supply Electrical System. (Recommended) Separate the wires coming out of the appliance conduit. Junction box Connect the white appliance wire to the neutral (white) supply wire in the junction box. WHITE Connect the black appliance wire to the black (L1) power WHITE...
Open and close the door completely to ensure that it is when you call. See inside cover for location. properly installed. Dacor is not responsible for the cost of correcting problems Reinstall the kick panel. caused by a faulty installation.