Installation Instructions ® Renaissance Gas Range Models: RNRP30G THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITIONS OF ANSI Z21.1 STANDARDS FOR HOUSEHOLD APPLIANCES. Part No. 108801 Rev. C...
Customer Service Information If you have questions or problems with installation, contact your Model Identification Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive RNRP30G S/NG/H Service line. Whenever you call, have the model and serial number of the appliance ready.
Use common sense and caution when installing, maintaining or operating this or any other appliance. WARNING Always contact the Dacor Customer Service Team about problems NEVER cover any slots, holes or passages on the inside or and conditions that you do not understand.
Page 4
Important Safety Instructions WARNING WARNING • Read the accompanying use and care manual before • Clean the cooktop thoroughly before operating it for the first operating this appliance. time. • Keep packaging materials away from children. Plastic • Keep flammable items, such as paper, cardboard, plastic sheets and bags can cause suffocation.
Planning the Installation Gas Supply Requirements WARNING • The installation of this appliance must conform with local • IMPORTANT: Observe all governing codes and ordinances codes or, in the absence of local codes, with the National during planning and installation. Contact your local building Fuel Gas Code, ANSI Z223.1/NFPA 54.
Planning the Installation Product Dimensions Product tolerances: ±1/16” (±1.6 mm) Front of open door 48” (121.9 cm) 28 1/2” (72.4 cm) Front of handle Front edge of bull nose 26 7/8” (68.3 cm) 26” (66.0 cm) Front panel Rear of front panel/oven door 24”...
5 inches beyond the bottom of the cabinets. outlet must be located so they do not interfere with the range • The range may be installed flush to the rear wall. Dacor when it is installed. strongly recommends installing a non-combustible material •...
Page 8
Planning the Installation Cutouts & Tolerances Cutout tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated Backsplash 27 1/2” (69.9 cm) 3 1/2” 3/8" (1.0 cm) min. for downdraft cap clearance non-combustible rear wall (recommended) 10" (25.4 cm) min. to combustible side walls above the range Note 2 (on both sides)
Installation Instructions Preparing for Installation Installing Rear Trim If installing the range in the self-rimming configuration, or if the WARNING range will be used with a downdraft, install the rear trim piece first. • If the gas or electric service provided does not meet the Remove the existing screws that hold the backguard in place and product specifications, do not proceed with the installation.
Page 10
Installation Instructions Installing the Anti-Tip Bracket to the Floor Installing the Anti-Tip Bracket to the Floor Determine the location of the range center line and front WARNING panel for the range’s final position based on the Product Dimensions on page 5 and the actual cabinet / cutout To perform its intended function, the anti-tip bracket must be dimensions used for the installation.
Page 11
Installation Instructions Installing the Anti-Tip Bracket to the Wall Installing the Anti-Tip Bracket to the Wall Determine the suitability of wall mounting the anti-tip bracket. To use the wall mount option, the range front panel (excluding the bull nose) must not be more than 27 inches (68.6 cm) from the wall, and the bracket screws must be able to thread Drywall into the back wall’s interal base plate (see Inside the Back...
Installation Instructions Removing the Oven Door Connecting the Gas WARNING WARNING • Do not attempt to disengage the hinge catches with the • Make sure the gas supply valve is off and that the power door(s) removed from the range. The hinge springs could cord to the range is disconnected prior to connecting the release causing personal injury.
Installation Instructions Re-installing the Oven Door(s) Finalizing the Anti-Tip Installation WARNING To avoid personal injury or damage to the door from it falling off its hinges: • Make sure that the notch on the bottom of each oven door Rear leg hinge locks inside the receptacle before attempting to open the oven door.
Installation Instructions Installing the Burner Knobs WARNING Installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the center burners are marked with the maximum griddle settings. NOTE: There is a “D”-shaped key on the back of the knobs that mate with a “D”...
Installation Instructions Assembling the Cooktop WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. Installing the Burners There are two types of burners: the Simmer-Sear burner (left) and the Standard burner (right). Refer to the illustrations and STEPS below when intalling the burners and grates.
OFF, and all burner rings, burner caps, and grates are properly placed on the cooktop. If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093 ex. 2822. Do not attempt to repair Turn the gas supply ON at the shut-off valve.
• Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor range cannot be overemphasized. □ Has the plastic coating been peeled off the outside of the...
Need help?
Do you have a question about the Renaissance RNRP30G and is the answer not in the manual?
Questions and answers