Advertisement
ASSEMBLY
9,
Make sure the front wheels point to the front. Attach the
steering wheel to the adapter. Fasten the steering wheel
with the large Washer, the lockwasher washer, and the bolt
shown in the illustration.
10.
Attach the steering wheel cap to the steering wheel.
1 1.
Connect the ends of the wires for the headlight. Before the
bezel can be assembled, the two screws at the front of the
control panel must be removed. Put the bezel in position on
the end of the control panel. Fasten the bezel with the screws
that were removed,
NOTE: if you do not follow
the above assembly instructions
correctly, the steering system will feel loose and the unit will
not steer correctly.
HOW
TO INSTALL
THE TILT SEAT
Assemble the seat with the fasteners shown full size below.
D-4583
Adapter
Post
D
I.
Align the four long holes in the seat support to the four holes
in the seat. Make sure the wire from the seat switch sensor
goes through the large hole in the seat support, Fasten the
seat to the seat support with the fasteners as shown, Do
not tighten.
2.
Move the seat to the best position for operating the unit.
Tighten the hex bolts.
3,
Connect the wire from the seat switch sensor to the wire
harness. Make sure the tab part of the connector, from the
seat switch sensor, locks into the latch of the wire harness
connector,
WARNING:
For correct and safe operation of the
unit, you must connect the wire from the seat
switch sensor to the wire harness.
SteeringWheel Cap=.....__
Steering _'¢heel
4.
Some
models
have two seat spring
caps in the parts bag,
D-4591-1
Mount
the caps on the seat springs
as shown.
c
Wire from
Seat Spring
Cape
Strap
Sensor"
F-88516
Bezel
Control Panel
D-4677
9
Advertisement
