Advertisement
REPAIR AND ADJUSTMENT
HOW TO REMOVE
THE MOWER
HOUSING
1,
Move the rift lever to the MIDDLE position.
2,
Move the blade engagement control lever to the DIS-
ENGAGE position,
3,
Disconnect the blade drive tink from the pivot md_nd
bracket assembly, See illustration "C" below,
4.
Remove the hair pins that hold the hangers to the adjuster
plates. See illustrations "A" and "B" below,
5,
Move the mower housing to the left until the right side
hanger separates from the adjuster plate, Then, move the
mower housing to the right until the left side hanger
separates from the adjuster plate.
6.
Remove the long ptnfrom the front suspension bracket. See
illustration "D" below,
7.
Remove the mower drNe belt from the stack pulley. Slide the
mower drive belt between the stack pulley and the belt
guide,
8,
Completely turn the steering wheel to the right, Pult the
mower housing away from the left side of the unit.
HOW TO INSTALL
THE MOWER
HOUSING
1,
Completely turn the steering wheel to the right, Push the
mower housing under the left side of the unit,
2.
Slide the mower drive belt between the stack pulley and the
belt guide. Put the mower drive belt around the stack puliey,
Make sure the "V" side of the mower drive belt isagainst the
stack pulley. Make sure the drive belt is not twisted.
3.
Attach the mower housing to the front suspension bracket
with the long pin. Fasten with the washer and hair pin. See
illustration "D" below,
4.
Attach the rear hangers to the adjuster plates. Fasten with
the hair pins. See illustrations "A" and "B" below,
5,
• Connect the blade drive link to the pivot rod and bracket
assembly, Fasten with a clevispin and a hair pin. See illustra-
tion "C" below.
6.
Move the blade engagement control lever to the ENGAGE
position, Make sure the mower drive belt is inside all the
belt guides.
7,
Check the operation of the blade engagement control lever.
See the instructions on "How To Adjust The Blade Engage-
ment Control Lever."
8.
Make sure the mower housing is level. See the instructions
"How To Level The Mower Houslng" in the maintenance
section of this book,
Stack Pul!
Beit
Driw
Link
Engagement Control
Adjuster Plato
Hanger B
Height of Cut
Lever
D
PullPin
Mower Drive Bel
A
uster Plate
D.4746-1
F-88516
2O
/
Front
Suspension
Bracket
Pivot Rod and _,_
BracketAssembly
"_
C
I
Advertisement
