Turning On The Tv/Vcr - Philips CCC192AT Owner's Manual

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure batteries are in the
remote control and you have connected the TV/VCR correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/B button to begin automatic channel
setup. The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on the screen
briefly. Then the TV/VCR will go to the lowest available channel.
If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on
the TV/VCR, then press the F.FWD/B button again. You may
need to follow the steps on page 10 instead.
5
o
Use the CH(annel)
on the remote control to select a TV/VCR channel. Use
o p
the VOL(ume) /
When you scan channels with the CH(annel) o/p buttons, only
the memorized channels will be available. Use the Number but-
tons to select non-memorized channels.
p
/ buttons or the Number buttons
buttons to adjust the sound.
1
EJECT
POWER
3
MENU STATUS/EXIT CLEAR
1 2
5
4 5
7 8
SLEEP/
ALT.CH
WAKE UP
0
REC PAUSE
/OTR /STILL
PLAY
REW F.FWD
STOP
CH.
MUTE
SPEED
TRACKING MEMORY
Helpful Hints
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine-10 to select a language and set
up channels.
• To skip step 2, press the MENU but-
ton. All on-screen displays will be in
English. To skip step 4, press the
STATUS/EXIT button. Automatic
Channel Setup will not occur, and
CHANNELS NOT SET will appear on
the screen briefly.
• You cannot set up channels if you are
using a Cable Box.
• Line Input mode is channel 00.
When you select channel 00, A/V IN
will appear on the screen briefly.
Press the CH(annel) o/p buttons or
the Number buttons to select another
channel.
2
3
6
9
4
VOL.