Table of Contents
Advertisement
3
Installation
B
Please remember that the
manufacturer shall not be held
liable if the information given in the
instruction manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be
emptied and cleaned prior to any
transportation.
2. Shelves, accessories, crisper and
etc. in your refrigerator must be
fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be adequate to
protect the product and the rules
of transportation printed on the
package must be followed.
Please do not forget...
Every
recycled
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental
authorities.
Before operating your
refrigerator
Before
starting
refrigerator check the following:
Is the interior of the refrigerator
1.
dry and can the air circulate freely in
the rear of it?
Clean
the
2.
refrigerator as recommended in the
"Maintenance and cleaning" section.
material
is
bodies
or
local
to
use
your
interior
of
Plug the refrigerator into the wall
3.
outlet. When the fridge door is open
the fridge compartment interior light
will come on.
You will hear a noise as the
4.
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
Front edges of the refrigerator
5.
may feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Electric connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
an
• The connection must be in
compliance with national
regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal
to your mains voltage.
• Extension cables and multiway plugs
must not be used for connection.
WARNING:
Do not locate extension sockets
or
charging
supplies or Lithium-Iron battery
operated products adjacent to the
compressor as they could overheat.
the
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated
before it is repaired! There is danger
of electric shock!
7
EN
transformers/power
Advertisement
Table of Contents
