Electrical Requirements; Warning! This Appliance Must Be Earthed - Beko BR 11 User Manual

Bu?lt under integrated refrigerator
Table of Contents

Advertisement

Electrical Requirements

Before you insert the plug into the
wall socket make sure that the volt-
age and the frequency shown on the
rating plate inside the appliance corre-
sponds to yourelectricity supply.
Rating label is on the left hand side
of fridge inner liner.
We recommend that this appliance
be connected to the mains supply via a
suitable switched and fused socket.
The appliance must be positioned so
that the plug is accessible.
Should the mains lead of the appli-
ance become damaged or should it
need replacing at any time, it must be
replaced by a special purpose made
mains lead which can only be obtained
from a Beko Authorised Service
Agent.
WARNING: When positioning the
appliance ensure the supply cord is
not trapped or damaged.
Warning! This Appliance
Must Be Earthed
If the fitted moulded plug is not suit-
able for your socket, then the plug
should be cut off and an appropriate
plug fitted. Destroy the old plug which
is cut off as a plug with bared cord
could cause a shock hazard if inserted
into a socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13 A fuse. Should the
fuse need to be replaced an ASTABEAB
approved BS 1362 fuse of the same
rating must be used. Do not forget to
refit the fuse cover. In the event of los-
ing the fuse cover the plug must not
be used until a replacement fuse cover
has been fitted.
Colour of the replacement fuse cover
must be the same colour as that vis-
ible on the pin face of the plug. Fuse
covers are available from any good
electrical store.
Important! Fitting A Different
Plug
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured mark-
ings identifying the terminals in your
plug proceed as follows: (See dia-
gram).
1. Connect the green-yellow or
green (Earth) wire to the terminal in
the plug marked 'E' or with the symbol
or coloured green and yellow or
green.
2. Connect the blue (Neutral) wire to
the terminal in the plug marked 'N' or
coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L' or
coloured red.
With alternative plugs a 13 A fuse
must be fitted either in the plug or
adaptor or in the main fuse box. If in
doubt contact a qualified electrician.
GREEN &
YELLOW
OR
GREEN
N
22mm.
BLUE
OR
BLACK
5
EN
6mm.
L
BROWN
OR
RED
CORD GRIP

Advertisement

Table of Contents
loading

Table of Contents