HobbyZone Conscendo S Instruction Manual page 8

EN
Wing Installation continued
1. Align the 4 wing bracket pins with the with the 4 cor-
responding fuselage holes as shown.
2. As you align the wing, guide the aileron servo wires
through the hole leading to the receiver compartment
on the underside of the fuselage.
3. Use 4 screws to secure the wing assembly to the
fuselage as shown.
4. Open the receiver hatch by removing the screw.
5. Connect the left and right aileron servos to the pre-
installed Y-harness. The left and right aileron servos
can be connected to either side of the Y-harness.
6. Secure the receiver hatch back into place using the
screw.
IMPORTANT: Correct operation of the SAFE system
requires connection of both ailerons to the included Y-
harness and the AILE channel of the receiver.
Disassemble in reverse order.
®
™
Conscendo S
1
2
4
5
8
3
OR