Haier HW80-1479 User Manual page 5

Control panel
3-Programme selector
3
15 min
By turning the knob one of 11 programmes can be se-
Sport 25 min
lected, related LED will light up, its default settings will
be displayed.
4-Function buttons
4
Delay
。
90 C 1400
The function buttons enables additional options in the
。
60 C 1000
selected program before program start. The related in-
。
40 C 500
dicators are displayed.
。
20 C
By switching off the appliance or setting a new pro-
gram, all options are disabled.
If a button has multiple options, the desired option can
4.1 4.2 4.3 4.4
be selected by pressing the button sequentially.
To delete the setting or to cancel the setting process,
press the function button until the desired LED lights
or -in case of only one option- the LED switches off.
Note:
To get best results in each programme Haier has well defined specific default settings. If
there is no special requirement default settings are recommended.
4.1 4.2 4.1-Function button „Temp."
。
90 C
1400
。 Touch this button to change the washing temperature
60 C
1000
of the programme.
。
40 C
500
。
20 C
4.2-Function button "Speed"
Touch this button to change or deselect the spin
of the programme.
4.3-Function button "Intense"
4.3 4.4
Intensifies cleaning results. Preferable if laundry is
heavily soiled. This extends the washing time in the
main wash cycle.
4.4-Function button"Extra Rinse"
Touch this button to rinse the laundry more intense
with fresh water. This is recommended for people with
sensitive skin.
By pressing the button several times one to three ad-
ditional cycles can be selected. They appear in the dis-
play with P--1/P--2/P--3.
8
GB GB
5-Function button „Start/Pause"
Press this button gently to start or interrupt the cur-
rently displayed programme. During programme set-
ing and during programme run the LED above the but-
ton is shining, or if interrupted blinking.
In conjunction with the end time delay button, the child
lock function can be switch on/off (see CHILD LOCK).
6- Display
The display shows following information:
▶ Washing time
▶ End time delay
▶ Error codes and service information
7- "Delay" button
Touch this button to start the programme with a de-
lay. End time delay could be increased in steps of 30
minutes from 0,5-24h. For example display off 6:30
means end of programme cycle will be in 6 hours and
30 minutes. Press "Start/Pause" button to activate the
time delay. It is not applicable to programme SPIN and
RINSE.
In conjunction with the "Start/Pause" button, the child
lock function can be switch on/off (see CHILD LOCK).
Note:
If using liquid detergent, it is not recommended to activate the end time delay.
Child lock
Touch button „Start/Pause" and end time delay button
for 3 seconds simultaneously to block all panel ele-
ments against activation. For unlocking please press
again the two buttons.
The display shows CLOI- if a button will be pressed,
when the child lock is activated. The change is not run-
ning.
Control panel
5
6
7
Delay
Delay
9