Haier HW80-1479 User Manual page 13

Installation
Moving the appliance
If the machine is to be moved to a distant location, replace the transportation bolts re-
moved before installation to prevent damage:
1. Remove the blanking plugs.
2. Remove the back cover
3. Insert the plastic spacers and the transportation bolts.
4. Tighten the bolts with a spanner.
5. Replace the back cover.
Adjusting the feet
Adjust all feets to achieve a complete level position.
This will minimize vibrations and thus noise during use.
It will also reduce wear and tear. We recommend to use
a spirit level for adjustment. Floor should be as stable
and flat as possible.
Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! If possible keep always drain
hose fixed to the clip at the appliance back.
CAUTION!
▶ Use only the supplied hose set for the connection.
▶ Never reuse old hose sets!
▶ Only connect to cold water supply.
▶ Before connection, check whether the water is clean and clear.
Following connections are possible:
2.
1.
1. Drain hose to sink
▶
▶
2. Drain hose to waste water connection
▶
▶
▶
24
Hang the drain hose with the U-support over the
edge of a sink with adequate size.
Protect the U-support sufficiently against slip-
ping.
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the
wastewater pipe.
Attach the U-support and secure it sufficiently.
GB GB
3. Drain hose to sink connection
▶
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion.
▶
Secure the drain hose with a clamp.
WARNING!
▶ The drain hose should not be submerged in water and should be securely fixed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80cm, the washing machine will continuously drain while being filled (self-si-
phoning).
▶ Drain hose is not to be extended. If necessary contact after sales service.
Fresh Water Connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled
end to the appliance. Tighten the screw joint
by hand.
2. The other end connect to a water tap with a
3/4" thread.
Note: Aqua-stop-system:
The aqua-stop system protects against water damage by automatically cutting the
fresh water supply in case of a leaking hose. This is indicated by a red marker (A). The
hose must be replaced.
Installation
3.
1. 2.
A
25