Makita HM1213C Technical Information page 13

R
epair
[3] ASSEMBLY/ DISASSEMBLY
[3]-5. Armature
ASSEMBLING
Take the disassembling step in reverse.
Note: Make sure that Flat washer 15 is set in place. (Fig. 20)
[3]-6. Electrical parts in Handle section
DISASSEMBLING
(1) Disassemble Handle section. (Fig. 4)
(2) The electrical Parts can be disassembled as illustrated in Figs. 29 and 30.
Fig. 29
Remove Handle cover. So the electrical parts, (Switch, Power supply cord, Terminal block etc.)
can be replaced.
Fig. 30
4x18 Tapping
screw (2pcs.)
Pull off Lever stopper with pliers. Switch lever can be removed.
Sponge sheet
Power supply cord
Lever stopper
Switch lever
Switch
Rubber pin 4 (green)
Pay attention not to
lose Rubber pin 4
when disassembling
Switch.
Terminal block
P 13/ 17