Advertisement
Quick Links
Advertisement
Related Manuals for Sime Super four
Summary of Contents for Sime Super four
- Page 1 Super four Installation and servicing instructions...
- Page 2 CONTENTS DESCRIPTION OF THE BOILER ................INSTALLATION .
-
Page 3: Description Of Boiler
European Directives pr EN 483 - pr EN de the ambiences in which they are 625. These appliances can be fired by “SUPER FOUR” boilers are gas-fired installed. natural gas and L.P.G. (G30 - G31). thermal appliances for C.H. and D.H.W. - Page 4 FUNCTIONAL DIAGRAM Sealed chamber Smoke pressure switch Water-gas exchanger Boiler expansion vessel System safety valve Hydrometer Modulating gas valve 100°C safety stat 12 Non-return valve 13 Boiler unit circulating pump 14 Manual bleed valve 15 Heating sensor (SM) 16 Water pressure switch 17 System circulating pump 18 D.H.W.
- Page 5 BOILER ROOM an adequate filter on the gas pipe. excess pressure by opening the relief valve on any radiator. Since the “SUPER FOUR” version boilers do not exceed the limit of 35 kW, they CHARACTERISTICS may be installed, without any constraints...
- Page 6 NOTE: The air intake-flue outlet assembly must slope gently downwards to prevent rain water getting into the boiler. 2.5.2 Coaxial air intake-flue outlet assembly accessories In addition to the coaxial duct kit, also the following can be supplied on reque- st (fig.
- Page 7 Standard EN 60730. 1 . temperature and flame modulation, with a built-in trimmer for adjusting NOTE: SIME declines all responsibility heating power output and warning leds for injury or damage to persons, ani- that indicate some of the possible failu-...
- Page 8 2.6.2 Wiring diagram Modulating coil Phase PA Water pressure switch Neutral C.H. circulating pump PF Smoke pressure switch PB D.H.W. circulating pump F1 Fuse (T 50 mA) SM Heating sensor (blue) F2 Fuse (T 1,6 A) SS D.H.W. sensor (red) Four-way switch EV1 1 gas valve...
- Page 9 NOTE: After setting the pressure The “L.P.G.-MET” connector link must level upon ignition (STEP) according The electronic card of “SUPER FOUR” be inserted on the type of gas for to the type of gas, check that the boilers is equipped with control leds which the boiler is arranged.
- Page 10 TEMPERATURE SENSORS tion electrode through the FM 31 SWITCH programmer, and the gas valve opens The “SUPER FOUR” boilers are equip- at the same time. The smoke pressure switch is located ped with sensors for detecting tempe- Burner ignition normally takes place inside the sealed- room (7 fig.
- Page 11 Gas cock Union C.H. return cock C.H. flow cock D.H.W. inlet cock D.H.W. safety valve System safety valve Water pressure switch Frost stat Fig. 13 SYSTEM AVAILABLE HEAD 1000 1500 FLOW RATE l/h Portata l/h Fig. 14...
-
Page 12: Use And Maintenance
Table 3 ; Since all “SUPER FOUR” versions are values given in Table 3 . – restore electric power to the modu- flame-modulation boilers, they have the lator and replace plastic cap (1). - Page 13 Pressure/heat output diagram for natural gas Heating potentiometer Trimmer Fig. 17 8, 1 (7.000) 11,6 (10.000) 17,4 (15.000) 23,2 (20.000) 29, 1 (25.000) HEAT OUTPUT kW (kcal/h) POTENZA TERMICA kW (kcal/h) according to a sequence already set Fig. 18 on the electronic adjustment card, will start modulating automatically, thus supplying the system with the actual power required.
- Page 14 to the combustion chamber; them out. – disassemble the gas burner-manifold – Unclog impeller of circulating pump, unit, as described in Section 4.5; clearing away any impurities or sedi- – to clean the burners, blow in a jet of ments. air, so as to remove any dust parti- –...
- Page 16 Sime Ltd Unit D2 Enterprise Way, Bradford Road, Idle, Bradford BD10 8EW Tel. 0870 9911114 - Fax 0870 9911115 www.sime.ltd.uk - e-mail: enquiries@sime.ltd.uk...
Need help?
Do you have a question about the Super four and is the answer not in the manual?
Questions and answers