Turning on the power
1.
projector and the outlet.
2.
Make sure that the POWER indicator
is lighted in steady orange. Then
remove the lens cover.
3.
Press the STANDBY/ON button on
the projector or the remote control.
The projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on,
the indicator will stop blinking and light in
steady green.
WARNING
not look into the lens of the projector or look inside of the projector through any
of the projector's openings, since the projection ray may cause a trouble on
your eyes.
NOTE
Manual - Operating Guide.
12
STANDBY/ON button
POWER indicator
User's
INPUT
MYBUTTON
ASPECT
PbyP
AUTO
FREEZE
MAGNIFY
FOCUS
ZOOM
VOLUME
ON
OFF
PAGE
UP
GEOMETRY
PICTURE
MUTE
DOWN
INTERACTIVE
NETWORK
BLANK
ESC
MENU
ENTER
OSD MSG
RESET