Replacing The Internal Clock Battery - Hitachi CP-WU5500 User Manual

Replacing the internal clock battery

Installing the battery is required in some cases. (
User's Manual - Network Guide) A battery is not contained at the time of factory
shipment. Please replace a battery according to the following procedure.
1.
Turn the projector off, and unplug the power cord. Allow the
2.
After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction indicated "OPEN"
using a coin or the like, and pick the cover up to
remove it.
4.
to take it out. Do not use any metal tools.
it may pop out of the holder.
5.
Replace the battery with a new HITACHI MAXELL,
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
6.
Replace the battery cover in place, then turn it in the
direction indicated "CLOSE
WARNING
And also improper use may result in cracking or leakage, which could result in
・
・ Make sure the plus and minus terminals are correctly aligned when loading a battery.
・
immediately for emergency treatment.
・ Do not short circuit or solder a battery.
・
・ If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
・ Obey the local laws on disposing a battery.
20
Always handle the batteries with care and use them only as
Event Scheduling in the
90°
OPEN
CLOSE
90°