Installation Instructions - AirClean systems AC600 Series Operator's Manual

Dead air workstation dead air box & timed uv light with uvtect controller

Hide thumbs

Table Of Contents

Table of Contents

DO NOT lift the workstation by the head assembly, the

sash, or any protruding wires.

CAUTION

1) If ordered, assemble the mobile cart. Assembly instructions are included with the cart and

also in the OPTIONS section of this manual. (Page 20)

2) Designate the appropriate installation location. Make sure that the desired area is stable

enough to hold the workstation and that there is an appropriate AC wall receptacle near the

workstation. Do not place workstations near doors or windows.

3) With the help of a co-worker, lift the workstation out of the bottom tray of the box. Make sure

to lift from the bottom of the workstation. See figure 2.

4) Place the workstation in the desired location. Once in place, make sure that it is secure

and stable.

5) Visually inspect your workstation, checking for any damage that may have occurred in

shipping. Pay special attention to the sash hinges. If damage has occurred, call AirClean

Systems immediately. DO NOT attempt to use workstation.

7) Make sure that the swell latches, located on the side lip of the head assembly, are in the

latched (down) position and that the head assembly is secure and properly seated. See

figure 3. (Page 10)