Get Ready To Fly: Pairing; Fly Your Drone; Trim Your Drone; Land Your Drone - Radio Shack Dominator User Manual

Get ready to Fly: Pairing

1. Turn on the drone. The drone's LEDs flash.
3. Place the drone on level ground.
4. Turn on the remote control. The remote control's LED flashes.
5. Move the throttle all the way up and then down to pair the
remote control with the drone. The drone's blades remain still
during pairing. When paired, the LEDs on both the remote
control and drone light steadily.
Note: If pairing fails, turn off the drone and remote control and repeat
the steps above, or change locations to avoid electrical interference.

Fly Your drone

1. After pairing, push the steering control in to switch between high
speed (double beep) and low speed (single beep).
2. With the drone on the ground, move the throttle forward to
ascend. To avoid ground air turbulence, fly the drone at least 1 ft.
(300cm) off the ground.
For advanced users: Hold the remote control with one hand,
resting your thumb on the throttle. Throw the drone about 9 ft.
(3m) away from you, and move the throttle forward to fly. The
drone adjusts itself automatically and flies smoothly.
iMPORtaNt: If your drone crashes upside down, pull the throttle
all the way down. Wait till the blades have stopped still before you
handle the drone.

Trim Your drone

Move the throttle forward and see how the drone reacts.
Forward/Reverse Movement trim: If the drone tends
to move forward, press
g
press .
Left/Right Slide trim: If the drone tends to slide right,
f
press ; if it tends to slide left, press
Note: The remote control beeps when you press a trim control, but
stops beeping when you reach maximum trim adjustment.
f
; if it tends to move backward,
g
.
8

Land Your drone

1. Slowly move the throttle backward to descend. Avoid moving
the throttle too quickly, as it can stop the blades instantly and
cause the drone to crash.
2. When you finish playing, turn off the remote control and drone.

Perform stunts

CaUtiON: Make sure there is enough space for the drone to
perform stunts without crashing into objects or people.
1. Push the throttle control to activate stunt mode. The remote
control beeps repeatedly.
2. Use the steering control to perform stunts:
• Front flip: Move steering forward
• Back flip: Move steering backward
• Barrel roll: Move steering right or left
3. The drone automatically exits stunt mode after performing a
stunt, or push in the throttle control again to exit immediately.

Calibrate the drone

If controlling the drone becomes difficult, try the following:
1. Select an open location free from strong magnetic interference.
Place the drone on level ground.
2. Turn on the drone and the remote control, and pair.
3. With the throttle all the way down, move the steering control all
the way up until the drone's LEDs flash rapidly.
4. When the drone's LEDs light steadily, your drone is calibrated
and should fly smoothly.
9