Charging The Battery; Operation - Eckman EKBP1 Instruction Manual

1. Blade-Fixed 2. Blade-Moving 3. The lock-off button 4. On/Off switch
5. The locking retractors 6. Charging socket 7. Charging light 8. Blade sheath
9. Strap 10. Battery Charger 11. Charger plug

Charging the Battery

Warning! Always push the lock-off button 3 to "OFF" position.
Do not use other battery chargers. The supplied battery charger is designed for Lithium-ion battery in
your machine.
Observe correct mains voltage: The voltage of the power source must agree with the voltage specified on the nameplate
of the unit. Equipment marked with 230 V can also be connected to 220 V or 240 V.
against deep discharging by the "Electronic Cell Protection". When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer rotates.
WARNING: Do not continue to press the On/Off switch after the machine has been automatically
switched off. The battery can be damage.
The battery is supplied partially charged. To ensure full capacity of the battery, completely charge the
battery in the battery charger before using your power tool for the first time.
A battery that is new or has not been used for a longer period does not develop its full capacity until after
approx. 5 charging/discharging cycles.
When the machine cannot rotate while the On/Off switch is pressed, then the battery has insufficient
capacity and should be charged.
Plug the mains plug of the battery charger 10 into a socket outlet and the charger plug 11 into the socket 6.
At this time, the battery charge-control indicator 7 lights up red. The battery charge-control indicator
indicates the charging progress. The indicator lights up red during the charge procedure. The battery is
completely charged when the indicator lights up green.
Disconnect the battery charger from the mains supply when not using it for longer periods.

Protect the battery charger against moisture!

Operation

NOTE: Remove the blade guard first before operating the machine.
Switching On and Off
To start the machine, remove the blade guard first and then push the lock-off button 3 to "ON" position, pull the locking
retractors 5 backward, then the moving blade 2 will move back until to the fully open position while pressing the On/Off
switch 4 at the same time. When the machine is running, maintain the On/Off switch state. The moving blade will go
forward until to the fully close position, and then stop.
To switch off the machine, release the On/Off switch 4 simultaneously. Do not release the locking retractors 5. The
moving blade will move back until to the fully open position, and then stop.
10
11
The Li-ion battery is protected
6