Adjusting The Tension Solenoid - Singer S-10 Service Manual

Snap ring
Fig. A
Thread tension release base
Shift the solenoid to the right to eliminate the gap.

Adjusting the Tension Solenoid

Setscrews
1.6 mm
Thread tension release rod
1. Remove the face cover, bed cover and front cover.
2. Lower the presser foot lifter.
Loosen the 2 setscrews.
3. Slide the solenoid to make a 1.6 mm gap between
the solenoid and snap ring while shifting the sole-
noid to the right (See fig. A).
4. Tighten the setscrews.
5. Attach the front cover.
19