Table of Contents
Advertisement
Returning to Factory Default Settings
Step 1
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the Off position
the third time.
Step 4
Shutdown Diagnostics
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1. Turn the Ignition switch to "On" position.
2. Press the (Car) button on the transmitter
3. The LED will now report the last system shutdown by flashing for 3 cycles in the following grouped patterns:
LED
Shutdown Mode
Flashes
1
(-) Safety Shutdown Input (Hood)
(+)Safety Shutdown Input (Brake)
or Neutral Safety Switch Input
Fail
3
No RPM or Low Voltage:
Check White/Red wire Connection
5
Over-Rev
6
System Timed Out
7
Tach. Signal has not been learned
3X
Before 15 seconds has passed, push
and release the valet switch 11 times
then push the valet switch a twelfth
time and hold it down until 6 short
chirps/beeps then release it. You are
now in the "Return to Factory Default
Setting" programming mode.
Turn On the Ignition
3 long chirps and 3 flashes of the parking lights will confirm exit of the programming mode.
Note: Waiting 15 seconds after the last command will also cause the system to
automatically exit the programming mode.
Step 2
11X + 1X (Hold)
1. Close the Hood
2. Check White/Black Wire Connection (7-Pin Mini Black)
3. Check White/Violet Wire Connection (7-Pin Mini Black)
4. Move the Enable Toggle Switch to "On" position
(If Installed)
5. Move the gear selector to "Park"/"Neutral" Position.
6. Check Black/White Wire Connection (7-Pin Mini Black)
Tachometer Checking Type:
Voltage Checking Type:
Program the "Check Level" from "Hi Check Level" to
"Low Check Level"
Re-learning the RPM
Step 3
Press the (Lock) and (Car) button on
the transmitter together for 6 seconds,
there will be a confirmation six chirp
with 3 long chirp and 3 parking light
flashes to confirm the system "Alarm
Features 1, 2 and 3 Programming" all
returns to factory default setting.
23
Advertisement
Table of Contents
