JVC XV-N30BK(MK3) Service Manual page 12

3.1.5 Removing the rear panel (See Figure 8, Figure 9)
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the five screws E attaching the rear panel.
(2) Disconnect the power cord from connector
power supply board
(3) Remove tie band.
3.1.6 Removing the output terminal board and power supply board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover/mechanism assembly/rear panel.
(1) Remove the two screws G attaching the output terminal
board.
(2) Remove the three screws H attaching the power supply
board.
(3) Disconnect the card wire from connector
power supply board.
1-12 (No.XA014)
P901 on the
G
Output terminal board
CN901 on the
Rear panel
E
E
Fig.8
CN901 P901
G
H
Power supply board
Fig.9
H
Tie band
Power cord
H