Set Function - afx light IPAR 518 Instruction Manual

SET FUNCTION
‐ Choose [SET] and press [ENTER]
‐ [UPLD] : sending edit program value from current master unit to slave unit : To do it, press [ENTER] then do
the key code [UP, DOWN, UP, DOWN] and press [ENTER], light turn to yellow, means data was sending
meanwhile there will show the speed of upload, light will turn to green when finished sending, and the slave
unit will turn to yellow too when receive the data,and turn to green when finished receiving. if the slave unit
protect to yellow,it means fail receiving, please cut off the power and receive again.
‐
[REST] : To load the factory setup. Press [ENTER] and do the key code : [UP, DOWN, UP, DOWN] then
press [ENTER]
‐ [ID] : ID address setting, Press [ENTER], press [UP] / [DOWN] to choose [ON] to allow ID address function,
[OFF] close ID address function
‐
[RGBW] : color deviation correcting setting, Press [ENTER], press [UP] /[DOWN] to choose [ON] to allow
color deviation correcting function,[OFF] not allow. the proportion of RGBW colors can be set in the menu
[CAL2]
‐
[DIM] : non-linear dimming setting, Press [UP] /[DOWN] to choose : [OFF] close dim speed, [DIM1] to
[DIM9] to choose speed ( speed 1 (fast ), ....., speed94 (slow), as the speed is slower as dimming softer.
‐ [DV] : Digital photography color choosen, Press [ENTER], and use [UP] /[DOWN] to choose between
[NTSC] or [PAL]
© Copyright LOTRONIC 2013 IPAR-518 Page 7