Hd Video Drone Battery Installation; Syncing The Hd Video Drone - Brookstone FlightForce Manual

HD VIDEO DRONE BATTERY INSTALLATION

Slide the fully charged battery into the HD Video Drone
battery compartment as shown in figure B . All LED
INDICATORS on the HD Video Drone will light up and
begin flashing when the battery is inserted correctly .
NOTE: The HD Video Drone has no on/off switch. It
automatically turns on when the battery is connected. To
switch off, unplug the battery.
18
Fig. B

SYNCING THE HD VIDEO DRONE

Important! When syncing the HD Video Drone with the
controller, always make sure that the HD Video Drone is
on a flat level surface and that your digital trim settings are
in the center position. This ensures that the 6-axis gyro is
properly programmed to mimic your trim settings.
The HD Video Drone utilizes an automatic 2 . 4 Ghz channel
selection system that allows up to 8 people to fly side by side in
the same wireless range with no interference .
FOR ONE-PERSON PLAY
1 . Before starting, make sure that the power on the
controller is off and the battery has been removed from
the HD Video Drone . Make sure that there are no other
2 . 4 Ghz devices in the area .
2 . Insert the HD Video Drone's battery and set the HD
Video Drone down on a flat surface . All LED INDICATORS
will begin to flash .
3 . Slide the ON/OFF SLIDE SWITCH on the controller to the
ON position . A beep will sound .
19