Controller Battery Installation; Charging The Hd Video Drone Battery - Brookstone FlightForce Manual

CONTROLLER BATTERY INSTALLATION

1 . Slide the battery cover off from the back of the controller .
2 . Install 6 AA alkaline batteries (not included) into the
controller .
3 . Replace the battery cover and secure it .
4 . Turn over the controller and turn the ON/OFF SWITCH
to the ON position . The POWER LED INDICATOR will
turn on and a beep will sound to indicate the batteries
are installed properly .
16

CHARGING THE HD VIDEO DRONE BATTERY

1 . Connect the included battery to the included
.
charging cord adapter
2 . Connect the USB charging cord to your computer's USB
port as shown in figure A . The red LED indicator on the
charging adapter flashes to indicate charging is in progress .
3 . When the HD Video Drone is fully charged, the charging
LED indicator will turn green . Average charging time is
approximately 50 minutes .
Note: A full charge will allow for about 5-6 minutes of flight
time. Unplug the charging cord when not in use.
USB
Fig. A
17