Kenmore 790.4025 Use & Care Manual page 9

Setting the Clock
The key is used to set the clock. The clock may be set for 12
or 24 hour time of day operation. The clock has been preset at
the factory for the 12 hour operation. When the range is first
plugged in, or when the power supply to the range has been
interrupted, the time in the display will flash. Press
display will stop flashing.
To set the clock for 1:30:
1. 1 Press once. CLO will appear in the display.
2. Press or until 130 appears in the display then
release the key. .
3. The time change will automatically be accepted after
approximately 3 seconds and will appear in the display.
Changing Between 12 or 24 Hour Time of Day Display
1. Press and hold for 7 seconds until 12Hr or 24Hr
appears in the display.
2. Press or to switch between the 12 and 24 hour time
of day displays. The display will show either 12Hr or 24Hr.
3. The change will automatically be accepted after approxi-
mately 3 seconds.
4. Press to cancel the setting.
5. Reset the correct time as prescribed in Setting the Clock
above.
Important note: If the 24 hour time of day was selected, the
clock will now display time from 0:00 through 23:59 hours.
Setting Continuous Bake or 12 Hour Energy Saving
The Timer On/Off and Self Clean keys control the Continuous
Bake or 12 hour Energy Saving features. The oven control has a
factory preset 12 Hour Energy Saving feature that shuts off the
oven control if left on for more than 11 hours and 59 minutes.
. The The oven can be programed to override this feature for contin-
uous baking.
To set the Continuous Bake or 12 Hour Energy feature:
1. Press and hold Timer On/Off for about 3 seconds. The
display will show either 12Hr OFF or Stay On and the
control will beep once.
2. Press Self Clean to switch between the 12Hr Energy saving
and Continuous Bake features.
Important note: 12 Hr OFF indicates the control is set for the 12
hour energy saving mode. Stay On indicates the control is set
for the Continuous Bake mode.
3. The control will accept your selection after a few seconds
and the display will return to show the time of day.
Setting Temperature Display -- Fahrenheit or Celsius
The Broil key is used to set the Fahrenheit or Celsius temperature
display. The oven has been preset to display in temperatures in
Fahrenheit.
Important note: Both ovens will be changed at the same time.
To change temperature display:
1. Press and hold the Broil key (for about 6 seconds) until the
control beeps and F or C appears in the display.
2. Press
Celsius modes. The setting will be automatically accepted
after approximately 3 seconds.
9
Setting Oven Controls
or to toggle to switch between Fahrenheit or