Panasonic CF-17 Reference Manual page 40

Dealing With Problems
When a problem occurs, please refer to this page. If you still cannot troubleshoot the problem, please contact Panasonic
Technical Support.
Starting Up
The power indicator or
battery indicator is not lit
is displayed
[POST Startup Error(s)]
is displayed
Windows startup, or an
operation is extremely
slow
The date and time are
incorrect
When the previous item
is not the cause
Battery Indicator
The red indicator lights.
Repeated beeping sound
while the computer is in
use.
The red indicator blinks
The orange indicator
blinks
Check the cable connection for the AC adapter.
Check to see if a fully charged battery is properly installed.
Remove the battery pack and disconnect the AC adapter, then connect them again.
Please input your password. If you have forgotten it, contact Panasonic Technical
Support.
page 38
1 Run the Setup Utility. (
2 Select [Exit] menu and select [Get Default Values], and then press Enter .
3 Select [Advanced] menu and set [Plug & Play] to [Disable].
Then, the Setup Utility must be run once again for you to input the appropriate operating
environment settings. (The processing speed depends on the application software used,
so this operation may not cause the processing speed to increase.)
You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control
Panel].
If you continue to experience problems, the internal battery maintaining the clock
may need to be replaced. Please contact Panasonic Technical Support.
When [APM 2.0 for NT] is not displayed in [Control Panel], this indicates that Phoe-
nix APM 2.0 for Windows NT
function is used under this condition, the date and time may be incorrectly dis-
played. Correct the date and time, and then install Phoenix APM 2.0 for Windows
NT ® . When the suspend or hibernation function is used frequently, discrepancies
may occur in the display of the date and time even if APM 2.0 for Windows NT is
installed. You can set the date and time through [Date/Time] in [Start] - [Settings] -
[Control Panel].
1 Run the Setup Utility. (
2 Select [Exit] menu and select [Get Default Values], and then press Enter .
3 Select [Advanced] menu and set [Plug & Play] to [Disable].
Try removing all peripheral devices.
The battery level is low. Save your data and power off your computer.
After connecting the AC adapter or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly remove the
battery pack and disconnect the AC adapter, then connect them again.
If the problem persists, contact Panasonic Technical Support.
Unable to charge because of an improper temperature range. (
tions")
(Advanced)
"Setup Utility")
® is not installed. When the suspend or hibernation
"Setup Utility")
40
"Precau-