Skoda Rapid Owner's Manual page 42

All seats occupied, boot loaded

Driver seat occupied, boot loaded

WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise there is a risk of an accident.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Notice
An audible warning signal will sound if the light switch is in the  or  posi-
tion, the ignition key is removed and the driver's door is opened. The audible
warning signal is switched off by means of the door contact when the driver's
door is closed (ignition off), however, the side lights remain on to illuminate
the parked vehicle if necessary.
Daytime running lights(DAY LIGHT)
The daytime running lights (hereafter referred to as function) provides the
lighting of the area in front of the vehicle.
The daytime running lights are switched on automatically if the following
conditions are met.
The light switch is in the position .

The ignition is switched on.

The function is activated.

Turn off LED daytime running lights function (vehicles with halogen
headlights)
›
Pull the indicator / main beam lever towards the steering wheel, push down
and hold in this position.
›
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
Activate LED daytime running lights function (Vehicles with halogen
headlights)
›
Switch off the ignition, pull the indicator / main beam lever towards the
steering wheel, push up and hold in this position.
›
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
40
Usage
Deactivate bulbs for daytime running lights function (vehicles with halogen
headlights)
›
Switch off the ignition and remove the fuse for the daytime running lights
» page 99.
Activate bulbs for daytime running lights function (vehicles with halogen
headlights)
›
Switch off the ignition and insert the fuse for the daytime running lights into
the fuse box » page 99.
WARNING
Always switch on the low beam when visibility is poor.
Turn signal and main beam
Control stalk positions » fig. 26
Switch on the right turn signal

Switch on left turn signal

Switch on high beam

Switch off main beam/switch on headlight flasher (spring-tensioned posi-

tion)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal switches off automatically, depending on the steering angle
after completing the turn.
Comfort signalling
When the operating lever is pressed lightly up or down, the indicator in ques-
tion flashes three times.
Fig. 26
Operating lever: Turn signal and
main beam operation
