Refit the headlight and grille
›
Replace the fog light by inserting it in the opposite direction of the arrow
and tighten.
» fig.
108.
›
Insert the guard and push it gently until it locks into place.
Removing/installing taillights
Fig. 109 Removing the light/pulling out the connector
Read and observe
and
Removing
›
Open the boot lid.
›
Lift up the cover in the direction of arrow
›
Hold the light in one hand and remove the plastic nut
arrow
with the other.
2
›
Hold the light and carefully remove it by moving it side to side.
›
Pull the connector lock
in the direction of arrow
B
›
Press the catch mechanism
C
›
Remove the connector.
Install
›
Insert the connector into the lamp and lock it securely.
›
Insert the light into the opening in the body.
›
Push in the light so that the light holder locks into the bolt on the outside of
the opening in the body.
›
Tightly screw the light with the plastic nut
row
» fig.
109.
2
›
Fold the cover in the opposite direction to arrow
on page 101 first.
» fig.
109.
1
in the direction of
A
.
3
in the direction of arrow
.
4
in the opposite direction to ar-
A
.
1
CAUTION
4
Ensure that the cable bundle does not become stuck between the body and
■
the lamp when it is being refitted – or there is a risk of damage to the electrical
installation and risk of water ingress.
If you are not sure whether the cable bundle has been pinched, we recom-
■
mend that you have the connection of the light checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing the bulbs in the tail lamp assembly
Read and observe
›
Unlock the bulb holder using the locking latches in the areas
page 105 marked with arrows and remove the bulb holder from the light.
›
Remove the faulty bulb
›
Insert a new bulb into the socket.
›
Turn the defective bulb
the holder.
›
Insert a new bulb
into the holder and turn in a clockwise direction to the
B
stop.
›
Insert the bulb holder in the light.
The lamp holder must engage firmly.
Fig. 110
Inner part of the light
and
on page 101 first.
» fig. 110
from the holder.
A
anticlockwise as far as it will go and remove from
B
Fuses and light bulbs
» fig. 109
on
105