Table of Contents
Advertisement
ENGINE OIL DIPSTICK - 1.5L
DURATEC-16V TI-VCT (81KW/
110PS) - SIGMA
A
B
E95540
A
Minimum
B
Maximum
ENGINE OIL CHECK
WARNINGS
Do not use oil additives or other
engine treatments. Under certain
conditions, they could damage the
engine and it is not covered under
warranty.
Empty engine oil containers should
not be disposed of in domestic trash
bins. Use only proper containers to
dispose of this type of waste.
When changing your oil, ensure that
the oil used is the same as specified
and the correct amount. Do not use
unknown types of oil or from already
opened containers.
Note: The oil consumption of new engines
reaches its normal level after approximately
5,000 km.
Checking the Oil Level
Note: Check the level before starting the
engine.
Ecosport (CBY) Rayong (Thailand)/Haiduong (Vietnam), enPHI
Maintenance
Note: Make sure that the level is between
the MIN and the MAX marks.
Note: Level measurement will not be
accurate if this procedure is not followed.
1.
Make sure that your vehicle is on level
ground.
2. If the engine is running turn it off and
wait 15 minutes for the oil to drain into
the oil pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the level is at the MIN mark, top up
immediately.
Topping Up
Only top up when the engine is cold.
If the engine is hot, wait 15 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Remove the filler cap.
Do not top up further than the MAX
mark.
Note: Oil expands when it is hot. Checking
the oil level when hot will be above the MAX
mark.
Note: Soak up any spillage with an
absorbent cloth immediately.
Top up with fluid that meets the Ford
specification. See Technical
Specifications (page 142).
Replace the filler cap. Turn it until you feel
a strong resistance.
119
WARNINGS
WARNING
Advertisement
Table of Contents
