Opening The Lock With Key; Inside Unit Programming; Adding The Pin Code; Resetting The Lock - Easy2Access EASY-908 Manual

will send out a wireless signal to disarm the alarm system (if such is also
installed).

Opening the lock with key

Opening with a lock is designed only for emergency solutions and must not
be used on a daily basis.
The key is turned ¼ from vertical to horizontal position. Turn the key back to
starting position after opening the door and the door is locked again.
Important
When a resistance is felt it is important to stop, the cylinder can become
•
damaged if continuing.
If the door is opened with a key, the door must be locked with the key
•
again in order for the electronic to function.

8. Inside Unit Programming

Only one set PIN code can be added on the inside unit. The Set number of
this PIN code is 1.
Normally the inside handle stays in unlock position.
▲

Adding the PIN code

A . Enter
1 23
＋ ＋ ＋ ＋
﹡ ﹡ ﹡ ﹡
w ith the Green LED blinking
＋ ＋ ＋ ＋ （
﹡ ﹡ ﹡ ﹡
the Green LED blinks again and one long beep is heard, the operation
succeeds.
Important Notes: The PIN code on the Inside Unit is an individual code
▲
and will remain unchanged no matter how the PIN codes on the outside unit
are changed.

9. Resetting the lock

Resetting the lock can only be performed by an authorized installer. It is
therefore of utmost importance that you remember your master codes,
which can add and delete all codes. Should you have forgotten the codes
Easy2Access A/S
﹡ ﹡ ﹡ ﹡ (with the Green LED blinking
＋ ＋ ＋ ＋
26
®
EASY-908 Pin Code lock
www.easy2access.net
)
N ew PIN code again
） ＋ ＋ ＋ ＋
N ew PIN code
＋ ＋ ＋ ＋
﹡ ﹡ ﹡ ﹡ .
When
＋ ＋ ＋ ＋