Important Notices - Dimplex FPE H Mounting And Operating Instructions

Mounting and Operating Instructions
FPE H, FPE V ecocomfort Radiant Heater

1. Important Notices

Read
all information contained in this manual carefully.
Keep these instructions in a safe place and hand them over,
if applicable, to the next owner.
The appliance is not intended for use
other heating room air in enclosed
rooms.
The appliance may only be installed
by an authorised qualified electrician.
All repairs and interventions in the appliance may only
be performed by qualified persons or the customer
service.
The hardwired electrical installation must be provided
with an all-pole disconnecting device with a contact gap
of at least 3 mm (e.g. automatic circuit-breaker).
It is imperative that all applicable regulations in accor-
dance with VDE 0100 Part 701 and all relevant installa-
tion instructions be adhered to.
In the event of any defect (e.g. appliance or power cord
is damaged, unit is not working), the appliance must be
disconnected from the power supply. Deactivate the cir-
cuit-breaker.
In the event of extended periods of non-use, the
appliance must be disconnected
from the mains power supply
Do not cover the heating appliance
as there is a risk of fire!
Do not allow appliance to be oper-
ated by children or other persons
not capable of safely using the device. Children must be
prevented from playing with or near the appliance.
Caution! The outside of the appliance gets hot when in
use.
Do not insert any objects into the openings of the appli-
ance.
If the supply cord of this appliance is damaged it must
be replaced by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard.
Do not use the appliance in areas where flammable
gases or liquids are stored or used.
Caution! After the appliance has been switched on
automatically, there is a potential fire hazard as the ap-
pliance may have been covered or obstructed prior to
switching on.
Make sure that minimum clearances, in particular from
easily inflammable materials or heat-sensitive plastic
materials, are maintained (see Section "2. Minimum
Clearances")
The supply cord must not be placed over the hot appli-
ance.
The appliance must not be disposed in
the normal household rubbish.
.
2. Minimum Clearances, Mounting
The heating appliance may only be mounted and operated
on a vertical wall. The operating panel must always be at
the top.
It must be ensured that the air can enter and exit the appli-
ance without any obstruction.
The appliance must be installed in such a way that switches
and other controls cannot be touched by the person using
the bath or the shower.
Do not mount the appliance directly under an electrical wall
outlet.
The mains socket must be accessible after the appliance
has been mounted.
It is absolutely necessary that the minimum clearances in-
dicated in the mounting diagram be maintained.
Beyond that, a clearance space of at least 1000 mm is to be
allowed in front of the appliance.
100
100
150
Dimensions in mm
Mounting procedure:
The appliance is not directly attached to the wall, but is to
be engaged in a wall bracket. The wall bracket supplied with
the heater must be used.
1. Drill the mounting holes for the wall bracket.
2. Firmly secure the wall bracket to the wall by means
of screws.
3. Engage heater in wall bracket using the slots pro-
vided at the rear of the appliance.
4. Fold up heater and lock it in position at the top of
the wall bracket.
4
453321.66.90gb 04/05/B
100
1000
100