Connections - Bush DLED49287HDCNTDFVP Instruction Manual

Connections

Bringing it all together
Connections
Connector
Connection
Connection
SIDE AV
PC/YPbPr
Connection
Connection
SPDIF
(Optical Out)
Connection
SIDE AV
Side AV
(Audio/Video)
Connection
HEADPHONE
Headphone
Connection
YPbPr Video
YPBPR
Connection
Connection
Connection
LAN
Ethernet
Connection
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14 Connections
Type Cables
Scart
(back)
VGA
(back)
Audio
YPbPr/PC Audio Cable
(side)
HDMI
(back)
SPDIF
(back)
AV Cable
(side)
(side)
(back) PC to YPbPr Connection Cable
USB
(side)
CI
(side)
LAN / Ethernet Cable
(back)
Device
NOTE: When connecting a
device via the YPbPr or Side AV
input, you must use the connection
cables to enable connection. See
the illustrations on the left side. |
You can use YPbPr to VGA cable to
enable YPbPr signal via VGA input.
| You cannot use VGA and YPbPr
at the same time. | To enable PC/
YPbPr audio, you will need to use the
Side AV input with a YPbPr/PC audio
cable for audio connection, using the
Side AV connection cable's RED and
WHITE inputs. | If an external device
is connected via the SCART socket,
the TV will automatically switch to AV
mode.| When receiving DTV channels
(Mpeg4 H.264) or while in Media
Browser mode, output will not be
available via the scart socket. | When
using the wall mounting kit (available
from third party in the market, if not
supplied), we recommend that you
plug all your cables into the back of
the TV before mounting on the wall.
| Insert or remove the CI module
only when the TV is SWITCHED
OFF. You should refer to the module
instruction manual for details of the
settings. | The/Each USB input of your
TV supports devices up to 500mA.
Connecting devices that have current
value above 500mA may damage your
TV. | By connecting an HDMI cable
to your TV, you have to use only a
shielded HDMI cable to guarantee a
sufficient immunity against parasitic
frequency radiation.
If you want to connect a device
to the TV, make sure that both
the TV and the device are turned off
before making any connection. After
the connection is done, you can turn
on the units and use them.