Troubleshooting Guide; Care & Maintenance - Curtis ILGD Service Manual

TROUblE-
ShOOTING
GUIDE
CARE &
MAINTENANCE
cauTIon: do
not use any
substance con-
taining chlorine.
These products
will promote cor-
rosion.
4
This appliance is designed for commercial use. any servicing other than cleaning and
maintenance should be performed by an authorized Wilbur curtis service center.
SyMPTOM: MOTOR DOES NOT RUN
POSSIblE CAUSE
1. Circuit breaker may be tripped.
2. Electrical cord may not be
making contact.
3. Electrical outlet may not
have power.
SyMPTOM: MOTOR RUNS bUT NO COFFEE COMES OUT
POSSIblE CAUSE
4. Shear disk may have broken.
5. Funnel to grind housing may
be jammed.
SyMPTOM: GROUND COFFEE TEXTURE IS TOO COARSE
OR OF POOR QUAlITy
POSSIblE CAUSE
6. grinding burrs may be worn.
7. housing cover may not be on
straight or not seating correctly.
REGUlAR AND PREVENTIVE MAINTENANCE IS ESSENTIAl IN
KEEPING yOUR GRINDER lOOKING AND wORKING lIKE NEw.
– ClEANING
1. The stainless steel outside case of the grinder may be cleaned with stainless steel polish.
2. Clean the hopper with a damp cloth.
3. you can clean inside the grinder housing with a stiff bristled brush to get out all of the old coffee
grounds. Refer to section on adjusting the grinds to open the housing. While cleaning the grinder, do not
wet inside the grinder housing.
SOlUTION
Grinder has a circuit breaker behind machine. Push in reset
button. you should hear a "click".
Push plug into outlet.
with voltmeter, determine if there is power at outlet.
SOlUTION
Change the shear disk (see page 6 for directions).
Cut off power to machine. Empty the hopper of beans.
Clean where the hopper funnels into the grind housing.
SOlUTION
Readjust the grind (see page 6).
Pull off the cover and clean the mounting surfaces.
Reassemble the housing.