Environmental Protection; Before Startup; Start Up - Kärcher HD 1.8/13 C Ed Operating Instructions Manual

Environmental protection

The packaging material can
be recycled. Please do not
throw the packaging materi-
al into household waste;
please send it for recycling.
Old appliances contain
valuable materials that can
be recycled; these should
be sent for recycling. Batter-
ies, oil, and similar sub-
stances must not enter the
environment. Please dis-
pose of your old appliances
using appropriate collection
systems.
Please do not release engine oil, fuel
oil, diesel and petrol into the environ-
ment Protect the ground and dispose
of used oil in an environmentally-
clean manner.
Notes about the ingredients
(REACH)
You will find current information about
the ingredients at:
www.kaercher.com/REACH

Before Startup

Check oil level
Read the oil level display when the

device is not running. The oil level
must be above the two pointers.
Activate deaeration of oil con-
tainer
Unscrew the fastening screws of

the device hood; remove the device
hood.
Cut off tip of oil container cover

Fasten the device hood.

Attaching the Accessories
Mount the nozzle on the spray pipe

(markings on the adjustment ring at
the top).
Connect ray tube to hand spray gun

Lever out the safety clip of the

handspray gun using a screw-driver
(Picture A).
Place the hand-spray gun upside

down and insert the end of the high
pressure hose till the end. Ensure
that the lose disc falls right below on
the hose end (Picture B).
Press the safety clip back into the

hand-spray gun. The hose can be
pulled out max. 1 mm if it has been
installed correctly. Otherwise, it
means the disc has been installed
wrongly (picture C).
Loosen the clamps of the pushing

handle.
Adjust the handle to the desired

height.
Tighten the clamps of the pushing

handle.
Fasten the high pressure hose to

the high pressure connection.
Electrical connection
Danger
Danger of injury by electric shock.
The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC
60364.
The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
The minimum fuse rating required at
the socket outlet is (see technical
specifications).
The appliance should always be con-
nected to the electrical mains using a
– 5
EN

Start up

7