JVC PD-35DX Service Manual page 9

2.4 DISASSEMBLY PROCEDURE [DISPLAY UNIT]
CAUTION:
• When exchanging parts etc. with the front side (PDP side)
facing down, please place a protection sheet below before
starting, so as to prevent scratches on the front side.
2.4.1 REMOVING THE REAR COVER (Fig.1)
(1) Remove the power cord / system cable / speaker cord.
(2) Remove the 14 screws [A] and the 6 screws [B], and
remove the REAR COVER.
(3) Remove the 1 screw [C], and remove the INSULATION
SHEET.
A A
(x4)
(x8)
2.4.2 REMOVING THE SPEAKER TERMINAL PWB (Fig.2)
• Remove the REAR COVER.
(1) Remove the 2 screws [D], and withdraw the TERMINAL
COVER.
(2) Remove the 6 screws [E], and remove the SPEAKER
TERMINAL PWB.
NOTE:
• Disconnect the connector [CN60SP] from the SPEAKER
TERMINAL PWB.
• It is advisable to take note of the connecting location
(connector number) of the removed connectors.
2.4.3 REMOVING THE AC INLET COVER (Fig.2)
• Remove the REAR COVER.
(1) Remove the 2 screws [F] and 1 screw [G], and withdraw the
AC INLET COVER.
NOTE:
• Disconnect the connector [CN0PW] from the LINE FILTER
PWB.
• It is advisable to take note of the connecting location (con-
nector number) of the removed connectors.
A
B
(x2) (x2)
B
(x4)
REAR COVER
C
INSULATION SHEET
Fig.1
D
(x2)
TERMINAL COVER
SPEAKER
TERMINAL
PWB
2.4.4 REMOVING THE LINE FILTER PWB (Fig.3)
• Remove the REAR COVER.
• Remove the AC INLET COVER.
(1) Remove the 6 screws [H], and remove the LINE FILTER
PWB together with the FILTER SHIELD.
NOTE:
• Disconnect the connector [CN00P] from the LINE FILTER
PWB.
• It is advisable to take note of the connecting location
(connector number) of the removed connectors.
2.4.5 REMOVING THE AUDIO PWB (Fig.3)
• Remove the REAR COVER.
• Remove the TERMINAL COVER and SPEAKER TERMINAL
PWB.
(1) Remove the 4 screws [I], and remove the AUDIO PWB.
NOTE:
• Disconnect the connectors
[CN60CA], [CN60CE], [CN60CF] from the AUDIO PWB.
• It is advisable to take note of the connecting location
(connector number) of the removed connectors.
2.4.6 REMOVING THE SYSTEM POWER PWB (Fig.3)
• Remove the REAR COVER.
• Remove the INSULATION SHEET.
(1) Remove the 4 screws [J], and remove the SYSTEM
POWER PWB.
NOTE:
• Disconnect the connectors [CN900J], [CN900P], [CN90CB],
[CN90CA], [CN900K] from the SYSTEM POWER PWB.
• It is advisable to take note of the connecting location
(connector number) of the removed connectors.
E
(x6)
F
(x2)
AC INLET
COVER
G
Fig.2
[CN60SP], [CN600K],
(No.52089)1-9
PD-35DX