Advertisement
Removing the elements
The element holders are spring loaded. To remove an element,
grip one end using a soft cloth to protect the surface, then push
carefully but firmly to one side until the other end disengages
from its socket. Withdraw the element carefully - see Fig. 5.
Refit in reverse order.
Cleaning the reflector
The reflector may be more easily cleaned if the elements are
first removed (see previous). Wipe the reflector with a warm
soapy cloth, then buff with a soft dry cloth.
DO NOT use abrasive cleaning powders or metal polish.
Lamp replacement
The fuel effect is secured by 2 screws, one at each end of the
fuel effect. Slacken these screws (do not remove them fully)
until the fuel effect is released, the lift it away.
Replace the defective lamp with a 60W B22 'Fireglow' lamp.
Reassemble in reverse order, ensuring that the diffuser/top
bracket arms are positioned correctly and the flicker rotors
spin freely.
Each flicker rotor should sit horizontally on its pin and spin
freely without fouling its mounting bracket. If necessary adjust
the bracket by bending slightly (the plastic diffuser is flexable).
Ensure flicker rotors rotate freely on
pins and that lamps are in sockets
correctly
Wall Mounting the Heater
Drill a hole using a 6mm drill central of where you wish to
place the product at a height shown below. Insert the rawl
plug provided and screw fix the strap at the rear of the fire to
the wall. Then place the heater against the wall with the strap
behind the heater. The rawl plug provided is suitable for use
in block or brick walls, special fasteners may be required for
stud walls etc.
Cleaning
Before cleaning the heater, disconnect it by pulling out the
plug from the wall socket. Do not use detergents, abrasive
cleaning powder or polish of any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be careful
not to allow moisture into the heater.
To clean the reflector, see 'Maintenance'.
Recycling
Fig. 5
For electrical products sold within the European
Community.At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer
for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (subject to availability) provided it
has been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales information or assistance
with this product, please contact 0844 879 3588 (UK) or
01 842 4833 (R.O.I.)
Please retain your receipt as proof of purchase.
Advertisement
