Troubleshooting Guide; Replacement Parts - Ninja BL450 Series Owner's Manual

Troubleshooting Guide

PROBLEMS
Motor doesn't start or Pro
Extractor Blades Assembly
doesn't rotate.
Food is unevenly chopped.
Food is too finely chopped or too
watery.
Cup is leaking.
Unit doesn't turn on.
Unit doesn't turn off.
Doesn't mix well.
Lid/blade assembly will not
properly align to the cup.

Replacement Parts

ORDERING REPLACEMENT PARTS
To order additional parts and attachments, please visit our website: www.ninjakitchen.com or feel free to contact customer
service: 1-877-646-5288.
14 1-877-646-5288
POSSIBLE REASONS & SOLUTIONS
Make sure the unit is plugged in.
Place the Nutri Ninja Cup onto the motor base, aligning the tabs on the cup with
the motor base.
Either you are chopping too much food at once, or you are not pulsing properly.
Reduce the amount of food in the cup.
The food has been over processed. Use short pulses for best results. Press down
on the cup in short intervals.
Make sure that your lid or blade assembly is properly assembled to the cup.
Leaking may occur if it is misaligned when twisted onto the cup. Turn the lid
tightly clockwise.
Make sure the unit is plugged in.
Make sure the Pro Extractor Blades Assembly is properly assembled to the cup
and that it is not misaligned.
Unplug the power cord from the electrical outlet and call customer service for
support.
Pulse ingredients for best results. Press down on the cup in short intervals for
even blending and chopping. For frozen ingredients, pulse in short intervals of
2-5 seconds and repeat.
Set the cup on a level surface. Place the lid or Pro Extractor Blades Assembly on
top of the cup and align the threads so that the lid/blades sit flat on the cup. Twist
clockwise so that the lid/blades evenly align to the cup until you have a tight seal.