Nutri Ninja ™ Pro Use - Ninja BL450 Series Owner's Manual

Use
WARNING: Handle the Pro Extractor Blades Assembly with care, as the blades are sharp.
WARNING: Never leave the appliance unattended while in use.
WARNING: Remove utensils prior to processing. Failure to remove may cause the bowl to be damaged or to
shatter, which may cause personal injury.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of the
user being burned.
CAUTION: Remove the Pro Extractor Blades Assembly from the cup upon completion of blending. Do not
store ingredients before or after blending in the Nutri Ninja cup with the blade assembly attached. Some
foods may contain active ingredients or release gases which will expand if left in a sealed container,
resulting in excessive pressure buildup that can pose a risk of injury. For ingredient storage in the cup,
only use spout lid to cover.
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 1 Fig. 2
1 Review warning and caution statements above before
proceeding to number 2.
2 Place the motor base on a clean, dry, level surface such
as a counter or table top.
3
Add ingredients to the Nutri Ninja
NOTE: Do not overfill! To avoid spilling, do not add
ingredients past the "MAX" fill line.
4
Place the Pro Extractor Blades Assembly onto the cup
and twist it on tightly until you have a good seal.
(Fig. 1)
5
Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor base.
(Fig. 2)
6
Press down on the top of the cup in short intervals to
activate. (Fig. 3)
PULSE
Fig. 3
For best results, use short "PULSES"!
cup.
™
Fig. 4
7 When you have reached your desired consistency, stop
the appliance by removing your hand from the cup. Wait
for the motor to stop running. Pull straight up to remove.
(Fig. 4)
8 Turn the cup upright and remove the Pro Extractor
Blades Assembly by twisting the Pro Extractor Blades
Assembly counterclockwise. (Fig. 5)
9 Do not store blended contents with the Pro Extractor
Blade Assembly attached.
10 Place the spout lid onto the cup, twist to seal and enjoy!
11 For storage, only use spout lid lid to cover.
12 Be sure to store the Pro Extractor Blades Assembly
attached to an empty cup when not in use.
13 Make sure that the motor base is unplugged when not in
use.
REMOVAL
Fig. 5
www.ninjakitchen.com 11