Powering on the Switch
Connect the power cord to an electrical outlet. Press the Power button to power on the switch.
See
Resetting to Factory Mode
To reboot the Cisco Edge 300 to factory mode and force an image upgrade through the Smart Install
network, press and hold the Reset button for more than 5 seconds.
If the Cisco Edge 300 is unable to connect to the Smart Install director, you can use the Cisco Edge USB
Note
SmartInstall tool to upgrade or restore the system firmware using a USB flash drive. Refer to the
"Troubleshooting" appendix in the Cisco Edge 300 Series Switch Software Configuration Guide.
Technical Specifications
Table 3
Environmental Ranges
Operating temperature
Storage temperature
Relative humidity
Operating altitude
Storage altitude
Physical Specifications
Weight (without bracket)
Dimensions (H x W x D)
OL-24909-02
Table 2 on page 6
for a description of the LED colors and their meanings.
Cisco Edge 300 Series Switch Environmental and Physical Specifications
23 to 104°F (–5 to 40°C)
–13 to 158°F (–25 to 70°C)
Operating and nonoperating: 10 to 90% (noncondensing)
Up to 10,000 ft (3000 m)
Up to 15,000 ft (4570 m)
2.43 lb (1.1 kg)
8.27 x 11.42 x 1.22 in. (21 x 29 x 3.1 cm)
Cisco Edge 300 Series Switch Installation Guide
Powering on the Switch
15