Cisco Edge 300 Series Installation Manual page 8

Installing the Switch
Statement 1019
The plug-socket combination must be accessible at all times, because it serves as the main
Warning
disconnecting device. Statement 1019
Statement 1030
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1040
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Statement 1044
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection:
10/100/1000 Ethernet Statement 1044
Statement 1047
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of:
104°F (40°C) Statement 1047
Statement 1074
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Statement 1076
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
Warning
3 inches (7.6 cm) Statement 1076
Be aware of the size and weight of the switch when mounting. Ensure that the mounting location has a
Caution
stable flat surface and can safely support the weight of the switch.
Cisco Edge 300 Series Switch Installation Guide
8
OL-24909-02