Installation /Initial Setup; Connecting All Devices To The Lcd Tv; Turning The Unit On And Off - Xoro HTL2722W Operation Manual

INSTALLATION /INITIAL SETUP

Connecting all devices to the LCD TV

1. Unpack your LCD TV and place it on a flat and horizontal surface in a well-
ventilated location.
2. Connect the output terminal of RF cable to the corresponding TV input terminal.
3. Connect AV signal output (DVD or other equipments) to AV input terminal of your
LCD TV with AV connecter.
4. Connect AV output of your LCD TV to AV input terminal of other AV equipments
with AV connecter.
5. Connect PC and HDMI connecting cables to the corresponding signal source
terminal.
Note:
When connect, plug directly and lightly to the interface, otherwise you may dam
age the stitch. Ensure that the power to the LCD TV and other connected devices
is disconnected before you make any connections.
6 . Connect the power cord to the outlet. Make sure that the voltage of your house is
meeting the voltage requirements as stated on the LCD TV's rear cabinet.
Note:
The power range of this product is 100v~240v, do not connect the power, which is
out of the range. When unplug the power cord, do not touch the metal part.
7. Ensure every AV signal cable is connected correctly to the corresponding port.

Turning the Unit On and Off

Turning On
Insert power cord into the wall outlet. Press the Power Switch on the unit, then press the
Power button on the remote control. The unit will be turned on and you will be ready to
use its features.
Turning Off
With the power on, press the Power on the remote control to turn off the unit, and put the
unit in standby mode. To cut off the power completely, press the Power Switch.
Unplug the power cord from the AC outlet if the TV will not be used for some tome
Note:
Please don't turn on the TV again before the indicator light is completely off.
Please do not turn on/off the TV too frequency!
Please Press the power switch on the unit to cut off the power completely when
the power is suddenly off!
Automatic power off if no signal is presented on the selected input
The TV set will automatically switch off and enter the standby mode after about 10 min-
utes if no signal is presented (e.g. no TV program signal is being transmitted from the TV
station) or if no operation is being done by pressing buttons on the TV set or on the re-
mote control.
25