General Function - Xoro HTL2722W Operation Manual

IDENTIFICATION OF CONTROLS

General Function

Standby Mode
Press the ON /OFF button on the TV panel/Remote Control, the LCD TV will store the
current setup and enter into the standby mode with a red indicator light.
When press the button again, the LCD TV will start to work again.
Signal Switch
Press TV/AV on the remote control to select the signal sources orderly. They are TV,
AV,SCART1AV, SCART2AV, S-Video, YPbPr ,VGA, HDMI,SCART2YC.
The upper-right corner of the screen will display the corresponding information.
Channel Selection
Press CH+/CH- on the panel or P+/P- on the remote control to increase/decrease the
channel number.
Note:
•
The biggest number you can input is 99/199 and use number buttons to input your
desired channel number.
•
During this input operation you can change to the corresponding channel directly
with pressing Enter, and press MENU to cancel.
Volume Control
Press V+/V- to decrease or increase the volume continuously when there is no any menu
displayed on the screen. The range is 0-100. The Volume menu will automatically be off if
there is no operation for about 4 seconds.
Channel no .
Press the NO button to enter into the channel directly. If press 2 or 3 digits continuously, it
will be 2 to 3 digitals channel number or it is one digit channel NO .
Mute
Press MUTE on the remote control to turn on/off the MUTE mode.
The symbol always remains on the upper-left corner of the screen whenever you do any
operation unless you turn the Mute OFF or adjust the volume.
Press MUTE or increase the value of volume, or adjust the items of the sound menu to
exit.
The TV is mute (but no mute symbol) with a blue background when no valid signal input in
TV mode.
14