Advertisement
3
In addition, there is a RESTORE button available on the front panel.
Insert a paper clip if a restore is required.
• A brief, momentary press: To delete a downloaded configuration and reboot.
• Press and hold for more than 10 sec: To force the unit into a full factory restore.
Management Port
This port is designed to access the local switch configuration page only. For more information on local configuration,
please see
Local
Configuration.
The management port can not be used as a standard switched port
The MS420 series will ship with all accessories, including fans and two power supplies. Additional accessories, including
fans and power supplies, can be purchased separately.
Equipment is to be used only in a restricted access location and installed/operated only by trained service personnel.
Bringing your Stack Online
When connecting up your MS420 for the first time the ports are set as ethernet. Once they're online you can convert the
port to a Stack port by simply selecting the option under the interface configuration as shown below:
It's recommended to bring the MS420's online using an uplink on each switch and configuring the port for Stacking prior
to connecting the stack links. This will allow for config sync as well as firmware upgrade. The switches will blink a white
status LED during upgrade so it should be visibly obvious that they're upgrade. When the Switch has a steady White
Light it's connected and ready to continue so the stacking connections can be added.
Switch Port LEDs
Off
Off
Solid orange
Solid green
Switch does not have
power
No client connected
10/100/1000 Mbps
10,000 Mbps (10Gbps)
4
Advertisement
