Turning Power On And Off; Loading And Unloading Discs - Alpine DVE-5300 Owner's Manual

3
Closing the cover
Slide the cover as illustrated until a click is heard.
Warning
DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR
ATTENTION AWAY FROM SAFELY DRIVING YOUR
VEHICLE.
Any function that requires your prolonged attention should
only be performed after coming to a complete stop. Always
stop the vehicle in a safe location before performing these
functions. Failure to do so may result in an accident.

Turning Power On and Off

Play Position Memory Function
If you turn power off or switch the ignition key to OFF during
playback, playback will continue from the point where
playback stopped when the power is turned ON again. The
play position memory is canceled when the disc is removed.
1
Press of the remote control.
The power turns on.
2
To turn the power off, press
10
-EN
again.

Loading and Unloading Discs

Turn on the power before loading and unloading discs. (Refer to
"Turning Power On and Off" on page 10.)
Loading discs
Insert the disc with the label side facing upwards.
Once the disc is partially inserted, it is drawn in automatically.
Playback starts.
• If the ignition key is on ACC or ON, a disc can be inserted even when
the power is OFF.
• For two-sided DVDs, play one side of the disc to the end, then unload
the disc, turn it over and reload it to play the other side.
• Never insert map discs for navigation purposes as they could damage
the equipment.
• If wrong disc, upside-down discs or dirty discs have been inserted,
"DISC ERROR" is displayed. Press
Unloading discs
Press .
Be sure to remove the disc.
• If the disc is not removed within a few moments, it will be reloaded
automatically.
• If the ignition key is set to ACC or ON, a disc can be removed even
when the power is OFF. After removing the disc, the power turns
OFF again automatically.
• During ACC OFF or while the disc is being loaded ("LOADING" is
displayed), the disc will not be ejected even if you press
and eject the disc.
.