Installation Conditions; Inlet And Outlet; Bends In 2 Or 3 Dimensions; T-Section - Honeywell VERSAFLOW MAG 1000 Quick Start Manual

VERSAFLOW MAG 1000

2.8 Installation conditions

2.8.1 Inlet and outlet

Use straight inlet and outlet pipe sections to prevent flow distortion or swirl, caused by bends
and T- sections.
Figure 2-7: Recommended inlet and outlet section
1 Refer to chapter "Bends in 2 or 3 dimensions"
2 ≥ 2 DN

2.8.2 Bends in 2 or 3 dimensions

Figure 2-8: 2 and 3 dimensional bends, in front of flowmeter
1 Bends in 2 dimensions: ≥ 5 DN; bends in 3 dimensions: ≥ 10 DN

2.8.3 T-section

Figure 2-9: Distance behind a T-section
1 ≥ 10 DN
34-VF-25-54 iss.3 GLO July 14 US www.honeywellprocess.com
INSTALLATION
2
11