Meaning Of The Error Codes - Saeco INCANTO HD8918 User Manual

English
24
The hot water dispensing
spout is not installed. Insert
the hot water dispensing
INSERT
WATER SPOUT
spout.
If the display shows an error
10
code, check section 'Meaning
of the error codes' to see
what the code on the display
xx
means and what you can do.
The machine cannot be used
when this icon is on the
display.

Meaning of the error codes

Error code Problem
01 The coffee grinder is
blocked
03 - 04 There is a problem
with the brew group.
05 There is a water
circuit problem.
14 The machine is
overheated.
Below you find a list of the error codes that may appear on the display, their
meaning and how to solve the problem. If these solutions do not help to
remove the error code from the display and bring the machine back to
normal working order, contact the Saeco hotline. Contact details can be
found in the warranty booklet or on
Cause
The coffee exit duct is
clogged.
The brew group is
dirty.
The brew group is not
positioned correctly.
There is air in the
water circuit.
This can have several
causes.
Insert the drip tray and close
the service door.
www.saeco.com/care
Possible solution
Clean the coffee exit duct thoroughly
with the handle of the measuring
spoon or a spoon handle. Switch the
appliance off and on again.
Remove the brew group and clean it
thoroughly (see 'Cleaning the brew
group').
Remove the brew group and reinsert
it. Make sure the two reference signs
on the side match before you slide
the brew group back into the
machine.
Remove and place back the water
tank a couple of times. Make sure
you insert it into the machine
properly. Check if the water tank
compartment is clean.
If you use an AquaClean filter:
remove the AquaClean filter from the
water tank and shake it to remove all
air from the filter. Then place the
AquaClean filter back into the water
tank.
Switch the machine off and switch it
back on again after 30 minutes. Try
this 2 or 3 times.
.