Landa ECOS 7000 Operator's Manual page 7

6. Lubricate all brake moving parts using a high
temperature brake lubricant. (Lubricate or
equivalent).
7. Remove any rust from braking surface and armature
surface of drums with fine emery paper or crocus
cloth. Protect bearings from contamination while
so doing.
8. Inspect oil or grease seals for wear or nicks.
Replace if necessary.
9. Lubricate hub bearings. Refer to procedure in
manual.
10. Reinstall hubs and adjust bearing per instructions
in manual.
TRAILER INFORMATION
9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12
PREVENTATIVE MAINTENANCE
This trailer was produced with the best available ma-
terials and quality craftsmanship. However, you as
the owner, have certain responsibilities for the correct
care of the equipment. Attention to regular preventative
maintenance procedures will assist in preserving the
performance of your vehicle.
Axles, Hubs and Brakes
Your trailer is equipped with Dexter Component Axles.
The Dexter Owner's Manual is included with your trailer
materials. Maintenance for these items is extremely
important for protecting the longevity of your trailer and
is important for your personal safety and the protection
of others.
Maintenance Schedule
Tire Air Inflate to proper pressure
Pressure
Wheel Lugs,
Tighten to proper torque
Bolts and specifications
Nuts
Wheel
Check for damage and or
out-of-round
Coupler Ball
Check for sufficient lube.
Check lock mechanism.
Check for unusual wear.
Safety
Check for abrasion, distor-
Chains at tion and general integrity of
Hitch Ball
links.
Coupler
Check for proper fastening
and hitch pin in position
and secure.
Brakes
Check for proper adjust-
ment& operation
Breakaway
Test switch operation and
Switch connections.
Breakaway Pull switch pin, check
Battery
charge indicator light.
Load
Check load distribution and
security.
Distribution
Leveling
Check fastenings, lube.
Jacks
Welds Check all weld beads for
cracks or separations.
Hinges
Grease zerks with a lithium
complex grease.
Tie Down Check for fracturing, distor-
tion and improper anchoring.
Devices
Electrical: Check to make sure all are
Lights and
working properly. Replace
Signals burned out bulbs.
* Check lug nuts for tightness before initial trip, then at 10 miles, 25 miles
and 50 miles. Recheck at least every 3 months or 3000 miles.
50 psi
Every 3000
mi or 3 mo.*
Every 6000
mi or 6 mo.*
Every trip
Every trip
Every trip.
Every trip
Every trip
Every trip
Every trip
Every trip
Every 6000
mi. or 6 mo.
Every 3000
mi. or 3 mo.
Every 3000
mi. or 3 mo.
Every trip
7